3D-printed bumper adds personality, protection to Moto 360 | Connectedly

3D-printed bumper adds personality, protection to Moto 360

3D-printed bumper adds personality, protection to Moto 360
By Chuong H Nguyen on 29 Oct 2014 05:39 pm

If you're looking for a little added pizzazz for your Moto 360 without spending a lot of extra money, then this inexpensive $8 3D-printed bumper case may be just the ticket. Essentially, it snaps onto the smartwatch and adds some color and personality to your wrist while at the same time protecting the stainless steel sides of the watch from being scratched or dinged should you inadvertently knock your wrist against a hard surface.

The bumper case is available in a number of different colors and adds a nice level of customization to the Moto 360 if you're bored of the stainless steel and black options for the watch.

Are you a fan of cases? What do you think about this bumper for the 360? Would you 3D-print your own bumper?

Source: Shapeways

Reader comments

3D-printed bumper adds personality, protection to Moto 360

3 Comments